How to Manipulate Button Bar

In a water jet cutting machine , when you open the NC system , starts to working , you will see Under AUTO mode, all picture manipulation button columns is POS Function Screen are the same, as shown in Fig five-twenty.

(LOAD)

Hotkey: F1, it is available only under AUTO mode. Pressing down the button will pop up “ Open and Load “ dialog , choose the target file, click(Open) button , and water jet system will load it into parse engine for machining.

(UNLOAD)

Hotkey: F1, it is available only under AUTO mode. Its function is to uninstall the loaded from NC Studio water jet system.
(BREAKPOINT RESUME)

Hotkey: F3, it is available only under AUTO mode. This button is only available when power-off, E-stop, or when user presses (STOP) button during water jet cutting machining process. If user can insure the accuracy of work piece coordinate, user can press this button to continue machining. If not, please go back to the reference point first and restart the water jet machining. This function can also be applied to simulation mode.
(SIMULATION)

Hotkey: F4, it is available only under AUTO mode. Simulation function provides user with a fast but lifelike simulation environment. Load a processing file, press(Simulation) button and then press (START) button on the operation panel, water jet cutting system will carry out simulation automatically system., but more advanced. To run a water jet cutting machining file under simulation mode, system will not drive the water jet cutting machine tool to do the relative actions, but only show the cutter race with high speed in the processing trace window. By simulation, user can know about water jet cutting cutter’s movement in advance, avoid damage (to the water jet cutting machine tool) which is caused by mistake in writing procedure, and get other additional information. By simulation, user can also know the machining information, which user can look over INFO function screen under POS function section.

(SELECT NPRECESSING)

Hotkey: F5, it is available only under AUTO mode. This function is used for program jump execution. Press down the button, system will pop up an “EXECUTE(ADVANCED OPTIONS)’”dialog box, as shown in Fig. 5-21/ Choose start position and end position in current machining program, then click “OK” button, the machine tool will carry out the selected block as requirement. This function can also be used for simulation.

(HANDWHEEL)

Hotkey: F6, it is available only ender AUTO mode. Press button (HANDWHEEL), user can control water jet cutting machine tool only by MPG; and then all of button on operating panel is invalid.

(Auto Back)

Hotkey: F7, it is available only ender AUTO mode. Press the button, a dialog “AUTO BACK” will pop up, and the water jet cutting machining program will be executed in reversed order. If user wants to change to Auto Forward or Stop state, please press the corresponding button on “Auto Back” dialog; if user closes the dialog, auto back state will be automatically substituted by auto forward state.



The article come from:http://www.waterjetchina.com/blog/index.php/how-to-manipulate-button-bar.htm


More about my article, you also can read:http://industrialgoods.devhub.com/