1, must ensure that the printer is working on a firm level surface, do not place anything on top of the printer. Printer must print off its front cover, to prevent dust or other hard objects into which impede the printer carriage movement inside the machine, causing unnecessary failures. If you open two cartridges (one black cartridge and a color ink cartridge) ink cartridge one cartridge in the random Gift Pack. Prohibit printing of a charging plug wires, it will damage the printer's printer port and the PC's parallel port, in serious cases, breakdown of PC boards. If the printed output is not too clear, stripes or other defect, free printer automatic cleaning feature to clean the print head, but requires a small amount of ink. If the continuous cleaning after a few prints are still not satisfactory, the ink may have run out, needs a replacement ink cartridge.
2, ensure that the environment clean. Using the environment too much dust, can easily cause Word guide shaft lubrication is not good, the print head movement is blocked during the printing process, print position is inaccurate or impact caused by mechanical frames causing panic. Sometimes, such panic because the print head is not returned to its original position, when you power on again, let the printer print head back to initial position, then cleaned the print head operation, causing unnecessary waste of ink. Solution to this issue is often guided axis dust off and shaft lubrication on Guide (selection, good mobility of lubricants, such as sewing machine oil).
3, when the ink cartridge is not used up, it is best not to remove, so as to avoid ink waste measurement to the ink or printer failure.
4, before shutting down, let the print head back to the initial position (under the printer in pause state, the print head automatically return to the initial position). Some printers before the shutdown automatically moves the print head to its original position, some printers must be shutdown confirmation in a suspended state (that is, suspended lamps or PAUSE led is lit) to shut down. Doing so is to avoid next time you power on the printer waste ink cleaning print head operation again; the second is because the print head in initial position may be subject to protection cover seal, make the nozzle wouldn't.
5, part of the printer in the initial position in mechanical locks. At this point if the moves the print head by hand, will not be able to make from the initial position. Be careful not to forcibly move the print head, doing so will cause damage to the mechanical parts of the printer.
6, changing print cartridge be sure to follow the steps in the manual, pay special attention to do this in a powered state. Because again replaced cartridge Hou, printer will on ink conveying system for filled ink, and this a process in closed machine state Xia will cannot for, printer cannot detection to again installed Shang of cartridge. also, some printer on ink capacity of measurement is using printer internal of electronic counter to count of (especially in on color ink using volume of statistics Shang), dang the counter reached must value Shi, printer judgment ink exhausted. Cartridge replacement process, the printer will reset its internal electronic counters, thus confirming the new cartridge is installed.
7, plug the printer power cable and print cable carried out be sure to power off the printer.
8, ink is not used for a long time should be placed to avoid direct sunlight at room temperature.
No comments:
Post a Comment